Needs to be 19mm
I think you mean 190mm
Might need a pipe on the end
If that's an 81mm, then yes.
"Find my missing 10mm socket, and I will move the world."
-- Archimedes (maybe)
/r/badphotoshop
No, it’s mislabeled. Must be a factory second. Definetly not an 18.
18 inches?
No, that's an SAE 18", Hondas are metric, you'll need a 455mm, that 18 will just round it off.
I thought you use a breaker bar and the starter?
Not on a lot of Hondas, they spin the wrong way.
It worked for our Odyssey thankfully. It was time for a new timing belt.
Below average photoshop.
Not big enough.
Is that the 10mm wrench?!
If you can find a 20 foot long piece of pipe to use as a cheater.
Nah it'll just round it off
Need a breaker bar but after that your golden lol
it would have but you got the wrong size………While you’re there will you check my blinker fluid thank you
Should've been a 10mm that's somehow going to STILL get lost never to be seen again.
No it's way too big.
When you find the right size, make sure you use the ratchet end to break the bolt loose, using an air chisel on the tool will help.
I think if drop that down on the engine bay you we’ll knock the engine out of the car.
Nope, that wrench is for lefties only. No right-handed mechanic can make this work.
I didn’t know they made wrenches that big
Must be in imperial millimeters
Not long enough, won't reach.
That removes the Jesus nut on a ch-53 helicopter!
No, but I do have this Honda crank pulley holding tool that I’ll give you so I can say I don’t have the tools to fix your RUSTED NIGHTMARE!!!!!
Tower of Pisa tourist vibes
Needs to be 19mm