[Image]

[Image]

I was having some problems with my printer so I decided to make it direct drive. This was a pretty easy install just kind of tedious. This was a video i used as a guide.

https://www.youtube.com/watch?v=kUmrwQTE7tY&ab_channel=JeDoVi3D

I printed this direct drive mount by Troy :

https://www.printables.com/model/613849-anycubic-kobra-max-direct-drive-oem

I had to buy m3 screws and nuts.

I also had to get an extended extruder cable (DISCLAIMER: YOU HAVE TO SWITCH AROUND THE WIRES TO WORK WITH THE EXTRUDER):

https://www.amazon.com/gp/product/B07QHTG82K/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1

I used the rest of the bowden tude that I didn't cut for to use for the direct drive extruder. With this feed tube bracker to guide the filment to filament senor:

https://www.thingiverse.com/thing:5748329

Also you are gonna need extra extruder fittings for the brackets (also they are nice to have around):

https://www.amazon.com/dp/B01NANKRTD

I am going to get new bowden tube to replace the stock one cause it is a little too short:

https://www.amazon.com/gp/product/B09GM6W972/

Oh and you will need to calibrate the extrude so it doesn't over extrude (this is a great video):

https://www.youtube.com/watch?v=ZfBOijl0Kd0&ab_channel=3DJake

[Image]

[Image]

I was having some problems with my printer so I decided to make it direct drive. This was a pretty easy install just kind of tedious. This was a video i used as a guide.

https://www.youtube.com/watch?v=kUmrwQTE7tY&ab_channel=JeDoVi3D

I printed this direct drive mount by Troy :

https://www.printables.com/model/613849-anycubic-kobra-max-direct-drive-oem

I had to buy m3 screws and nuts.

I also had to get an extended extruder cable (DISCLAIMER: YOU HAVE TO SWITCH AROUND THE WIRES TO WORK WITH THE EXTRUDER):

https://www.amazon.com/gp/product/B07QHTG82K/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1

I used the rest of the bowden tude that I didn't cut for to use for the direct drive extruder. With this feed tube bracker to guide the filment to filament senor:

https://www.thingiverse.com/thing:5748329

Also you are gonna need extra extruder fittings for the brackets (also they are nice to have around):

https://www.amazon.com/dp/B01NANKRTD

I am going to get new bowden tube to replace the stock one cause it is a little too short:

https://www.amazon.com/gp/product/B09GM6W972/

Oh and you will need to calibrate the extrude so it doesn't over extrude (this is a great video):

https://www.youtube.com/watch?v=ZfBOijl0Kd0&ab_channel=3DJake

I am looking for a Computer Hardware Engineer to interview for a school project also I very interested in the job. I just want ask a few question about the job.