I'm using PLA Anycubic High speed Filament. This just started happening when I changed filament. It seems to mainly do this on the x axis. The instructions for the filament say to print it at "180-210℃ 50-150mm/s", "210-230℃ 150-300mm/s", "230-260℃ 300-600mm/s". I tried printing the filament at each speed except for 600mm/s, and at the correct temperature, and it still came out rough like this. I also tried adjusting the z offset and re-autoleveling. It wasn't doing this the last time I printed something, but I was also using different PLA filament. Should I try replacing the nozzle at this point? Any suggestions are appreciated, thanks in advance. :)
The easiest thing to start with is to try the first Pla you used. That way, you can rule out Pla as the issue. Next, check for a loose bed or hotend, rollers. Good luck.