How to calibrate X/Y axis? K2Plus?

Hello i got problems i wanted to print a Project but this has to be good in dimensions.
for test i printed a Circle with inner diameter 110mm outer diameter 116mm. i got 109,6mm and 115,7mm. Where i can set the correction or steps?

in anycubicby Opening-Winter-8250

100%

3mo

Suspicious_Dog1922

3mo

Goodluck one one helped me so far

Catnippr

3mo

You can't - and even IF you could, you shouldn't mess with the steps of the x/y/z steppers, as those are determined by the hardware (yes, I know, many YouTubers tell you to print a 20x20 calicube and adjust the steps accordingly if it's not 20x20, but that's pretty much bs..).

But: we're talking about 0.4mm and 0.3mm difference/deviation here, which is ~0.36% and ~0.26% in this case - that's pretty darn good. Your measuring tool probably has about the same amount of measuring error, assuming it's not a super high precision pair of calipers.

Besides that, filament does shrink when it cools down - so you have to keep that in mind as well.
Your only option here (imho) is to adjust slicer settings to compensate this.