Reprinted and looks kinda better than the previous attempt. Any other ways to improve for a smoother print?
HelpView all comments
I changed the bed temp and now the print is sticking to the nozzle. What’s the best bet?
Did you set your Z height? Do you know what that is?
Please do yourself a favor and go to YouTube and start watching videos on 3D printing for beginners. NO shame in being a beginner, you got to start somewhere.
There is just too much for us to cover, and you know so little you can't even articulate most of what is going on.
Yeah my z height and offset is all set. But it still just won’t stick properly
Most times if it's not sticking then your bed is dirty or it's Z height. Wash the bed with soap and water, thoroughly dry it. DO NOT TOUCH THE BUILD PLATE WITH YOUR HANDS, this will make it greasy and prevent prints from sticking. Also clean it often with isopropyl.
No shade being thrown here, I find it hard to believe you can properly set Z-height yet don't know how to set temps or even proper temps for filaments.
I encourage you to spend some time learning more. There's so much to absorb and you're already starting off on the wrong foot.