Hello,
I'm currently printing some additions to a wooden marble track with wood-infused PLA and with the last 2 models the following problem occurred: The model looks like it has been cut and shifted a little bit (see pictures).The cube that was printed as a whole is stable, but there is a cut right above where the holes for the inner tunnels end. For the first element I tried to use bridge settings (Cura) to improve those areas, but since the print obviously didn't turn out the way I wanted it to, I deactivated the bridge settings again for the second element. The problem still occurred. The slicer does not show any unusual behaviour at those layers. Does anybody have an explanation to what might have happened and an idea how to fix this?
Thanks in advance!
Printer: FLSUN QQS
ProFilament: Wood PLA (210°C printing temp., 70°C bed temp)
Slicer: Cura 5.4.0
Complete Cube printed with enabled bridge settings
Second (failed) print printed without special settings
No support in all cases
Infill: 45 + % because I need the weight
If the printer is retracting at the end of each the grid infill lines the problem would be heat creep.
All3DP - Heat Creep