The gate to Crow Creek Falls is closed by fwp on Oct 15th
A friend send me some dick picks awhile back. They're hilarious.
I'm jonesin for a K1 max .. but holding out for the K2.
K2 comes out possibly in July. K1 price will probably drop more.
I've never came this way before .. must be the cobble-car
Highly recommend tuning your z offset. Looking at the purge line and the line around the project, they don't look squished. I use a 1st layer stl that is a basic 60mm square. As it prints, I'll adjust the z offset and wait for 10mm of the print to complete and adjust again. I usually put a black dot with my sharpie to mark the change. When it's done printing, I'll inspect it on the build plate as well as with a light source shining through. I'll usually adjust 2 or 3 times per print. Sometimes, I'll go through 3 prints before it's tuned.
This is a fucked up genie wish. Dude asked for "two women at the same time man"
Nuttin' but a good time
Yes everything is included. The Milwaukee collection is crazy
I dated a twin in college. Her brother had a bigger penis.
It's only gay if your balls touch
Was plastic wrap mode enabled?
Plz go pet your dog for me.
You should see what I can do
If this works out can you repost to this sub later? Would like tp hear the outcpme.
So, this happened today (yes it is my x axis belt and yes i have a project due tuesday and no electronic shop that sells belts near me)
3Dprinting