Hi everyone,
I keep having problems with the first layer not sticking properly to the printbed of my Kobra 2 Pro. I print the same thing twice and get very different results. I have noticed that the print bed has a lot of play. When you take the PEI sheet off and put it back on there can be differences of up to half a millimetre. I have already tightened the nuts on the Y-gantry and also adjusted the pressure on the ball bearings using the concentric nuts, but there has been no improvement. Is it normal for the Y-gantry to have so much play? What can I do about it?
Thank you all!
Wobble Wobble Wobble Wobble Wobble Wobble Wobble Wobble Wobble Wobble
The rollers under the right side of the printer bed are adjustable with a 10 mm wrench. It looks as though they need adjusted. If they are snug, remove the entire bed, and tighten the pegs that hold the rollers to the bed. I found I had one of these loose.