HI! I made a bed visualizer on octoprint and this result came out. How can I improve the bed? 1mm seems too much to me
Tighten the front right knob and loosen the left rear knob. Half a turn each should be enough.
What knob are you talking about?
What printer do you have?
Kobra 2 neo
Look in to silicone or springs for the plate
https://1coderookie.github.io/Kobra2NeoInsights/hardware/bed/#mod-longer-spacers
Look for adjustable spacers
i recommend silicone spacers as theyre more rigid than springs, on my kobra 1 neo i use them and they work great, would also be advisable to do the mod using knobs for adjustment instead of manually turning each screw at each corner of the bed, although i haven't tried that yet
thanks for the advice, since it was 1mm just right I tried adding a washer to the different spacer, now it's much better. The deviation is only 0.35mm
If it's still lower at the same spot, maybe try to shim it out even more. Best would be to get a deviation that's within the height of your first layer.