Hi all, I got an X2 years ago and it's been amazing, until yesterday.

It jammed so hard I broke the cleanout tool trying to get it out, I disassembled the hot end and found a chunk of unmelted filament jammed in the hot end body, a good 1" long piece...I removed it, replaced the nozzle with a fresh one, levelled the bed etc etc etc... and... still having issues...

I've tried using cleaning filament, other filament brands and nothing, when I tell it to auto load it'll squeeze a little out (not nearly the normal amount) sometimes then go an jam again.

When I tell it to print it might squeeze a bit out but then it just stops, the extruder gear is working fine, it's doing it's best to push but it keeps clogging.

A Few times when I'd pull the filament out the end of it would be all stringy and like, broken stringy sections.

All my filament is stored in a sealed bin full of desiccant*

Is there a chance my hotend is trash? It says it's getting up to to temp, the nozzle feels scalding hot so... what gives? I've ran into jams and stuff before and small issues that I resolved quick but this is very puzzling...