Not sure if x-axis twist or gantry twist is the right thing, but one side of my bed is consistently higher/lower than the other.
What parts should I check? Do I disassemble it and put it back together with more straightness/precision?
View all comments
That seems to do nothing for me. It's like I didn't do it at all. Where do settings get saved. ? Because I can't find them.
You should see the values at the end of your printer.cfg. Did you remember to save_config?
It was saved. Not sure why I couldn't see it before. Found it down below like you said. I ran it again and hit save config on mainsail instead of what popped up on sovol screen. I disable mesh in start code and did test print. It was indeed working this time. I put mesh back in and ran level test again. It changed slightly but still good and proof axis_twist_compensation was working. My bed is kinda wacked. But I know it wasn't a bed issue as the "wack" was the opposite of what was happening. It was axix twist. It's been this way from day one. Going to work on bed level with either tubing or nylock. Then run all that stuff again. With Michael Hill software on marlin I got very good prints after implementing "axis twist". V57 but wanted to print faster. And keep quality. So trying klipper. Thanks for all the help on here.
Glad to hear you're making progress!