Hello all!
I have had my Ender 3 S1 for a while. I've been upgrading it over the past couple of months (silent fan mods from Nathan Builds Robots), a Fulament Bed, etc.
I have a question about the included power supply....
I have noticed that when I have a light plugged into the same surge strip as my Ender 3 S1 I can see flickering in the light as it is printing. Starts as soon as the hot end starts heating up. I know this is from conducted emissions being kicked back onto the power line. My question is, would upgrading to a real Meanwell power supply fix this? Should I put the printer on a UPS to help quiet down the emissions?
Some Electronics introduce wierd beshvior like that. I would just use a different Outlet. For Me it was a small fridge that Turned only the GPU off when the Compressor Started running